My Cart 0
$0.00
Free shipping on every item
Parts Finder

How to reverse door for Hoshizaki AM-50BAJ(AD)

224 views  September 10, 2020

If you would like to reverse the door swing, follow the steps below.
1) While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out
the bottom of the door slightly and gently remove the door from hinge (A). See Fig. 1.

AM-50BAJ_-DS_-AD_-ADDS

2) Remove the 2 screws securing the top panel, then lift it off. See Fig. 2.

AM-50BAJ_-DS_-AD_-ADDS

3) Remove hinge (A) and the bracket from the right side of the unit and the top brace from
the left side. Rotate hinge (A) to position the gasket notch to the inside, then fasten
hinge (A) and the bracket to the left side and the top brace to the right side. See Fig. 3

AM-50BAJ_-DS_-AD_-ADDS

4) Remove hinge (B) from the right side of the unit and the 2 filler screws from the left side.
Attach the 2 filler screws to the right side and attach hinge (B) to the left side. See Fig. 4.
5) Rotate the top panel 180° from its previous position. This brings the notch that was
previously in the right rear to the left front. See Fig. 5. Hook the rear part of the panel on
the body, then secure the front with the 2 screws removed in step 2.

AM-50BAJ_-DS_-AD_-ADDS

6) Remove the 2 screws attaching the door handle and also remove the other 2 screws
indicated in the illustration. Use 2 of the screws to attach the handle to the other side of
the door and attach the other 2 screws in the remaining 2 holes. See Fig. 6.
7) Attach the door to hinge (A), then continue to maintain a hold on the door. Screw the
hinge stop pin into hinge (B) until it is tight. See Fig. 7

AM-50BAJ_-DS_-AD_-ADDS


Did you find it helpful?
   Ask a question

Terms & Conditions

There is no content for Term & Conditions.
I Agree with the Terms